Cristofoli Autoclave Quadra 54, Manual

Page: 24 / 26

POSSIBLE CAUSES
SOLUTION
• The wiring voltage/amperage is lower than the one needed for
the autoclave --------------------------------------------------------------------
• VSPF valve ----------------------------- Pressure/steam leak through the
• --------------------------- Pressure/steam leak through the door gasket
• ----------------------------- Insufficient amount of water in the reservoir
• --------------------------------------------------------- Overloaded chamber
•Have a professional electrician to make the necessar y
modifications of your workplace wiring. See "
Installation Instructions ”
topic “ Electrical Installation ” (Page 8);
•See “ How to Proceed when Service is Needed ” (Page 24).
•Perform preventive maintenance (Page 20);
•·Check the water level in the reservoir, if necessary, fill it up to the
correct level;
•Do not put more instruments than specified in each bag /package.
Use up to 75% of the chamber's capacity, that means, 20 envelopes
for Quadra 54 liters (10 x 23 cm containing 4 instruments
each).·Remember to leave some space between the envelopes to
allow good steam circulation and optimize drying. Never overlap
envelopes.
THE AUTOCLAVE TAKES TOO LONG TO BUILD UP PRESSURE OR DOES NOT KEEP IT, SHOWING THEN THE MESSAGE “CYCLE CANCELLED”
If the problem persists after the verification of all the items listed, contact your local dealer.
23
CRISTÓFOLI
A U T O C L A V E S
I N S T R U C T I O N M A N U A L