F
IBER
S
CAN
ONE
™
4.2 Turning FiberScan
ONE
™ on and off
To turn the instrument on, please hold down the ON/OFF key on the control
unit for a few moments. Once the display lights up, you can release the key.
Figure 7 - Power button
To turn the instrument off, hold down the ON/OFF key again for at least 1
second; the word “
SHUTDOWN
” will appear on the display, and after a few
seconds, the unit will turn off.
CAUTION!
During the sampling process or any other situation when the
control unit accesses the internal memory in write mode, the
ON/OFF switch deactivates, to avoid any writing errors which could
compromise the integrity of data already saved.
In the upper right side of the main screen it is shown the battery indicator.
If battery level is too low, the instrument alert the user by blinking the battery
icon.
CAUTION!
Measurements taken with “low battery” warning could be less
accurate.
If the battery level goes lower, the instrument will turn automatically off, to
preserve the memory. To continue the use of the instrument, it must recharge
the battery using the accessory provided for this purpose. Please consult the
chapter 4.3.0 Recharging the instrument.
FiberScanONE™ User manual rev. 1.0.2
Page 19 of 74