IR Wireless Touchpanel
Crestron
ST-1700CIR
Appendix: Installation of Optional Pushbuttons
The ST-1700CIR is supplied with ten optional pushbutton switches, blank buttons,
and a bezel to accommodate the switches. As a further option, custom engraved
black buttons (1700C-BTNB) or silver buttons (1700C-BTNS) can be designed and
purchased via the Crestron Engraver software. Version 2.4.1.2 or later is available
from the Crestron website.
Perform the following to install pushbuttons on the ST-1700CIR. Follow these same
basic procedures to replace the blank buttons with the optional engraved buttons. A
#1 Phillips screwdriver is required. Refer to the illustration below.
1. Place the touchpanel face down on a clean work surface.
2. Remove the four screws securing the front bezel to the base. Holding the
bezel to the base, return the unit to its normal position and lift the bezel
from the base.
3. Assemble the supplied membrane switches to the pushbutton sets. Notice
that the pushbutton sets fit snugly on the membrane switches. (Refer to the
following Notes.)
4. Put the assembled pushbuttons and switches in place (refer to the following
Notes), and place the new bezel in position.
NOTE:
The rear of the pushbuttons are marked 1-5 TOP and 6-10 TOP to ensure
correct orientation when installed. Do not remove the plastic frame connecting the
buttons together.
NOTE:
Carefully position the switch/pushbutton assemblies on the printed circuit
boards–edges should be aligned–and place the bezel over the pushbuttons to hold
them in place.
5. Hold the bezel in position and turn the unit over on its face.
6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,
being careful not to strip the threads.
7. Verify that the pushbuttons function properly.
Optional Pushbutton Installation Diagram
Pushbuttons
5
10
Membrane
Switches
Screw
Screw
Bottom view
Bezel
24
•
SmarTouch™ IR Wireless Touchpanel: ST-1700CIR
Operations Guide – DOC. 6469
