Crestron
IDOC-PAD-DSWC
In-Wall Docking Station for iPad
®
NOTE:
The IDOC-PAD-DSWC is designed for use with the original iPad while the
IDOC-PAD2-DSWC is designed for use with the iPad 2. A conversion kit
(IDOC-PAD-DSW-*-S CONVERSION KIT) is available to allow the
IDOC-PAD-DSWC to be used with an iPad 2. For instructions on installing the
conversion kit, refer to the latest version of the IDOC-PAD-DSW-*-S
CONVERSION KIT Installation Guide (Doc. 7215) which is available from the
Crestron Web site.
Install the Faceplate
Install the faceplate as follows:
1.
Carefully position the faceplate over the face of the docking station.
2.
Ensure that the faceplate is oriented properly and press against the
IDOC-PAD-DSWC until the faceplate snaps into place.
Docking Station Removal
If it is necessary to remove the docking station after it has been installed into a
mounting surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #2 Phillips tip screwdriver.
1.
If the iPad is in the docking station, remove it from the docking station as
described on page 12.
2.
Lift one edge of the faceplate to free it from the docking station, and lift it
off.
3.
Loosen and remove the screws that secure docking station to the mounting
option in use.
NOTE:
If the mounting clips were used, make sure that the screws stay
attached to their mounting clips.
4.
Using equal pressure, carefully remove the docking station from the
opening.
If necessary, secure and label the attached power cable before disconnecting it from
the back of the docking station.
Hardware Hookup
Ventilation
The IDOC-PAD-DSWC should be used in a well-ventilated area. The venting holes
should not be obstructed under any circumstances. If the IDOC-PAD-DSWC is hot
to the touch, consider using forced air ventilation.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications. Consideration
must be given if installed in a closed or multi-unit rack assembly since the ambient
operating temperature of the environment may be greater than the ambient room
temperature. Contact with thermal insulating materials should be avoided on all sides
of the unit.
Connect the Device
Make the power connection as called out in the illustration on the following page.
Refer to “Wiring” on page 5 before attaching the 2-position terminal block
connector. Apply power after the connection has been made.
Operations & Installation Guide – DOC. 7084A
In-Wall Docking Station for iPad
®
: IDOC-PAD-DSWC
•
9
Summary of Contents for IDOC-PAD-DSWC
Page 4: ......
