Crestron
DVPHD
High Definition Digital Video Processor
Configuring the Video Processor
NOTE:
In order to configure the DVPHD, power and a connection to an external
touch screen or a connection via Ethernet are required. Refer to “Hardware Hookup”
which starts on page 41 for details.
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the interface for normal operation. The
method for accessing these setup screens differs depending on whether an external
touch screen or an Ethernet connection is used.
To enter Setup via the Web
interface:
Enter the IP address provided for the video processor on the network. The e-Control,
XPanel interface is displayed. Click on the
Setup
button.
To enter Setup via the touch
screen:
Place a finger on the touch screen, left click the mouse or press the
Display 1
front
panel button as power is applied, or after the hardware reset button is pressed and
released. Remove the finger when the message "Entering Setup. Please wait while
system initializes." briefly appears on the touch screen.
To enter Setup via the front
panel menu:
Access Setup by pressing the
Enter
front panel button. Select ENTER/EXIT SETUP
PAGE and press
B5
(
SAVE
).
Upon entering setup mode, the “Main Menu”, as shown in the following illustration,
displays five buttons:
Touch Screen Calibration
,
Reboot and Run Project
,
Exit
Setup and Run Project
,
Setup
, and
Diagnostics
.
The
Exit Setup and Run Project
button verifies that all of the setup information has
been saved to the EEPROM and displays the main page that has been programmed
into the system. The remaining buttons on the Main Menu open other menus, which
are discussed in subsequent paragraphs.
“Main Menu”
Operations Guide – DOC. 6545C
High Definition Digital Video Processor: DVPHD
•
15