14 • DM-NVX-E760 and DM-NVX-E760C
Product Manual — Doc. 8918B
Automatic Point-to-Point Connectivity
Point-to-point connectivity enables the DM-NVX-E760(C) to be connected directly to a DM NVX
decoder to stream video and audio. Rather than being connected to an Ethernet switch, a
1000BASE-T Ethernet port of the DM-NVX-E760(C) is connected directly to a 1000BASE-T port
of the decoder. By default, point-to-point mode is enabled (set to Auto) and can be disabled if
desired. When enabled, no additional configuration is required for the DM-NVX-E760(C) to
operate in point-to-point mode.
To enable or disable point-to-point mode, use the web interface or SIMPL Windows as discussed
in the following sections.
Using the Web Interface
Enable or disable point-to-point mode by clicking the Settings tab and then clicking System
Setup.
In the Point-to-Point Control section, Point to Point Status indicates whether point-to-point
mode is Active or Inactive.
In the Point-to-Point mode drop-down list, select either of the following:
l
Auto: (Default setting) A 1000BASE-T port of the DM-NVX-E760(C) detects a direct
connection to a DM NVX decoder or a connection to a 1000BASE-T switch. If a direct
connection to a decoder is detected, point-to-point mode is automatically enabled.
l
Disable: Disables point-to-point mode
