Cameo
™
Keypads
Crestron
C2N/C2NI-CB Series
4. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.
The keypad can be mounted directly to a mounting surface or it can be
mounted to a back box. In both cases, you can choose to have mounting
screws visible or hidden.
Mounting to the Mounting Surface
Use the supplied template to prepare the hole in the wall. (Refer to the
Appendix on page 40 for an illustration of the template.) After the
Cresnet network wiring has been installed and verified, use the following
procedure to install the keypad in the prepared hole.
1. Put the plastic wall plate in position over the prepared hole and
attach using two screws (not supplied) appropriate for the
mounting surface. (Refer to A in the figure on page 22.)
2. Turn Cresnet system power
OFF
, and connect the Cresnet cable
to the keypad’s Cresnet port, using the supplied mating
connector.
3. Insert the keypad into the hole and press the bezel against the
plastic wall plate until it snaps securely into position.
4. Turn the Cresnet system power
On
.
If the keypad needs to be removed from the wall, there are two slots on
one edge of the bezel (visible in the figure on page 22). Use a flat blade
screwdriver to pry the bezel away from the wall plate, being careful to
avoid damage to the bezel.
Mounting to a UK-Style Back Box
Prepare the hole in the wall appropriate for the back box. (Back boxes for
these keypads are typically square or rounded and have tabs with screw
holes for mounting the keypads on each side rather than top and bottom.)
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypad in the back box.
1. Put the plastic wall plate in position over the back box and
attach using the supplied 7/8 in. pan head screws. (Refer to B in
the figure on page 22.)
20
•
Cameo™ Keypads: C2N/C2NI-CB Series
Operations & Installation Guide - DOC. 6346A
