Crest Healthcare Pro R:1
SUPPLEMENTAL INFORMATION
5
5.1 Important User
Information
The information included in this section of the Operator Manual is
intended to give the operator a general description and technical
specifications of the P
J
Cleaning Systems. Contact CREST to
schedule a technician to test your installation and demonstrate
proper equipment operation.
After installing cleaning system according to the previously supplied
Equipment Utility Requirements and Specifications
and
Equipment
Drawings
, complete the following checklist to ensure complete and
correct installation:
5.1.1 Installation Checklist
Shutoff valves (not provided by CREST), for maintenance
purposes and capable of being locked in OFF position only,
installed on air and water lines and in compliance with local
occupational health and safety regulations, as well as electric and
plumbing codes.
Disconnect switches (not provided by CREST), for maintenance
purposes and capable of being locked in OFF position only,
installed in electrical supply lines near unit and in compliance with
local occupational health and safety regulations, as well as electric
and plumbing codes. Disconnect switches must bear the
identification of the equipment to which they are connected.
NOTE: If unit is installed next to other equipment, shutoff valves
and disconnect switches should be located so that service can be
shut off to one piece of equipment at a time.
Cleaning system is positioned on a hard, non-combustible, level
surface as shown on equipment drawing, with required clearance
space and in relation to building supply lines.
Cleaning system is level. Use leveling legs if necessary.
For cleaning system, verify lid counterweights shipping bracket
and hardware are removed from rear of cabinet (see
F
IGURE
5-1
).
Building cold water line supplies water to unit as specified on
equipment drawing.
Building hot water line supplies water to unit as specified on
equipment drawing.
Floor sink is provided for unit drain connection. Power and gravity
drains are run separately to the floor sink and are not connected.
Verify all quick disconnect clamps are tightened. Tighten if
necessary.
❑
❑
❑
❑
❑
❑
❑
❑
❑
5-1
Supplemental Information
Operator Manual
REMEMBER – POSSIBLE
TIME DELAY: Insufficient
clearance space will make
repairs more difficult and
time-consuming. Refer to the
equipment drawing for
minimum clearance for
service/maintenance access
requirements.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
Failure to remove shipping
bracket and hardware from lid
counterweights results in lid
and/or unit cabinet damage.
IMPORTANT: A listing of the Safety Precautions to be observed when operating or servicing
this Pro Ultrasonic Cleaning Systems can be found in
S
ECTION
1
. Do not operate or service
equipment until you have become familiar with this information.
