Site Requirements
13
Air Supply
The Lotem 400 / Lotem 400 Quantum output device requires a clean, dry,
oil-free,
dust-free, and moisture-free
air supply at 7 bar (100 psi), of shop air according to the
table that follows:
*SLPM measured at 7 bar, SCFM measured at 100 psi
A standard 1/4’’ BSP port female outlet connector is required. It should be
mounted on the wall up to 5 m from the device.
The air supply should conform to ISO class 4.
•
Maximum particle size 15 µ (0.006 in.)
•
Concentration of solid contaminants: 8 mg/m
3
(0.000216 oz./yd.
3
)
•
Maximum pressure dew point 3°C @ 8 bar [37.4°F @120 psi]
•
Maximum oil content 5 mg/m
3
(0.000135 oz./yd.
3
)
Examples of typical compressed air systems that you may use:
For Lotem 400
For Lotem 400 with MCU
Configuration
Average air consumption*
Compressor air supply*
Lotem 400
10 SLPM (0.35 SCFM)
70 SLPM (2.47 SCFM)
Lotem 400 with MCU
90 SLPM (3.18 SCFM)
170 SLPM (6.0 SCFM)
Note:
Do not add lubricant.
Note:
The temperature of the airline going from the drying device to the machine must
be kept above 3° C.
Manufacturer
Kaeser
Atlas Copco
Compressor type
Piston
Piston
Compressor Model
Premium-Silant 130/10
LFx-1.0-T20
Air receiver (liter)
10
50
Dryer (230 V-AC)
TAH-4
FX1
Automatic Water Drainer
according to air receiver according to air receiver
Manufacturer
Kaeser
Atlas Copco
Compressor type
Screw
Screw
Compressor Model
SX-3
GX2-10 (50 Hz)
Air receiver (liter)
250 (or 280)
250
Dryer (230 V-AC)
TA-5
FX1
Automatic Water Drainer
ECO-21-PLUS
WD80
