ASSembly inStruCtionS
© Copyright 2005, Creative Playthings, printed in U.S.A.
PINE SKYBOx SPIRAL SLIDE
19694-200 Rev C (07-16)
Page 4
SteP 3 - Side Supports
Locate the two Side Supports (K). Align the large hole at
the top of each Side Support (K) with a hole drilled in the
Wall Support in the previous step. Make sure that the Side
Supports (K) are plumb. Fasten each Side Support (K) to the
Wall Support using one #10 x 2-1/2" Wood Screw through
the small holes at the top of the Side Support.
Fasten the bottom each Side Support (K) to the Platform
Support using two #10 x 2-1/2" Wood Screws through the
small holes at the bottom of the Side Support. the space
between the Side Supports should be approximately 24".
note: this and all subsequent steps show the Spiral Slide
attaching to the end of the Skybox. the procedure is the
same to mount the Spiral Slide to the side of the Skybox.
SteP 4 - Side Fillers
Fasten a Side Filler (L) to each Side Support (K) using two
#10 x 2-1/2" Wood Screws through the holes provided.
Make sure that the inside edges of the Side Support (K) and
Side Filler (L) are flush.
Side mounted Spiral Slide
drill Holes for a Side mounted Slide
Use the Mounting Plate (A) to lay out the
mounting hole positions. Align the top edge of
the Mounting Plate (A) with the top edge of
the Side Wall Support. The top left hole of the
Mounting Plate (A) should center 6-3/4" from
the end of the Side Wall Support, as shown.
With a pencil, mark the position of the four
holes at the corners of the Mounting Plate (A).
Bore holes through the Side Wall Support and
Side Platform Support at the pencil marks,
using a 3/8" diameter drill.
SteP 2 - drill mounting Holes (continued)
Side Wall
Support
Side Platform
Support
A
6-3/4"
Wall Support
Platform
Support
K
L
K
