PINE SKYBOx SPIRAL SLIDE
19694-200 Rev C (07-16)
© Copyright 2005, Creative Playthings, printed in U.S.A.
Page 7
ASSembly inStruCtionS
Side mounted Spiral Slide
SteP 13 - lower Slide Support bracket
At the point where the Spiral Slide comes closest to the
Safety Rail (J or M), remove two of the hex bolts on the
Spiral Slide and attach the Lower Slide Support Bracket (H)
using the same hardware.
Mark the place where the holes on the Lower Slide Support
Bracket (H) encounter the Safety Rail. Drill 3/8" diameter
holes at the marks.
Attach the Lower Slide Support Bracket to the Safety Rail
(J or M) using two 5/16 x 1-1/2" Hex Bolt Assemblies.
SteP 12 - Safety rail
end mounted Spiral Slide
end Safety rail.
Locate the small holes in the Skybox Corner Posts
approximately 24" up from the bottom of the Posts. Drill
out these holes to 9/32" diameter. Fasten the End Safety
Rail (M) between the Corner Posts using two 5/16 x 5-1/2"
Lag Screws and two Flat Washers, as shown. It may help
to lubricate the threads of the lag screw with wax.
Side Safety rail.
Locate the small holes in the Skybox Corner Posts
approximately 24" up from the bottom of the Posts.
Fasten the Side Safety Rail (J) to the Gym Corner Post
and Skybox Corner Post using two 5/16 x 2-1/2" Lag
Screws and two Flat Washers, as shown. It may help to
lubricate the threads of the lag screw with wax.
J
M
Skybox
Corner
Post
Skybox
Corner
Post
Gym
Corner
Post
Lower Slide
Support Bracket
Safety Rail
