ASSembly inStruCtionS
© Copyright 2005, Creative Playthings, printed in U.S.A.
PINE SKYBOx SPIRAL SLIDE
19694-200 Rev C (07-16)
Page 8
Ground Level
Anchor Nail
5/16 x 12"
SteP 14 - Anchoring run-off Section
Drill two 5/16" holes through each side of the lower flange on
the Run-off Section. Hammer the two Anchor Nails into the
ground to anchor the front of the Spiral Slide.
NOTE: The Anchor Nails will hold better if they are driven in
at a slight angle as shown in the illustration.
SteP 15 - restore Platform boards
Restore the Platform Boards that were removed in step one
using the screws originally used.
Check to make sure all hardware is
tight and secure. Insert Hole Caps
into the counter-bored holes on
the Side Safety Rail (if used).
SteP 16 - bottom Filler and Slide mount
Locate the Bottom Filler (N) and Slide Mount (O). Place the
Bottom Filler (N) against the Platform Support between the
Side Supports (K), as shown. Two edges of the Bottom Filler
are rounded. Be sure to place the Bottom Filler (N) with the
rounded edges up.
Place the Slide Mount (O) tightly against the Bottom Filler
(N). Center the Slide Mount in front of the slide opening.
Fasten the Bottom Filler (N) and the Slide Mount using the
#10 x 2-1/2" Wood Screws provided. Do not overtighten the
screws. Overtightening may cause the screws to protrude
below the Platform Boards.
N
O
K
Save all instruction sheets and receipts in case it becomes necessary to contact Creative Playthings
for warranty service and/or part replacement. the warranty can be found in your owner’s manual.
Please fill out the warranty card on the back of your owners manual. your completed warranty card will
allow us to quickly process warranty claims.
thank you.
