Assembly
© Copyright 2005, Creative Playthings
Pine Skybox
19690-100 Rev J (06-16)
Page 12
ASSeMbly InStRuCtIonS
illustration #18
illustration #19
illustration #17
SteP 7 - Inside Stringers:
Locate the two inside Stringers (G). The inside Stringers (G)
are installed between the Platform Sides (W). Attach each
inside Stringer (G) using two 5/16 x 4" Lag Screws and Flat
Washers as shown. make sure the end Stringer (e), Platform
Support (Z) and inside Stringers (G) are aligned across top
edges..
G
y
e
Z
y
SteP 8 - Angle braces:
Fasten an Angle brace (A) to each end of the Platform
end (R) using two 5/16 x 2-1/2" hex bolt Assemblies. do
not tighten these bolts yet. The Angle braces (A) should be
fastened so that the angled end is flat against the nearest
Corner Post (d).
A
d
d
R
SteP 8 - Angle braces (continued):
Level the Skybox. Tighten all connections except the Angle
braces (A). do not over tighten.
Position the Angle braces (A) with the angled ends flat
against the Corner Post nearest to each. With a pencil, mark
the position where the holes in the Angle braces rest against
the Corner Posts. At each mark drill a 1/8" diameter x 2"
pilot hole in the Corner Posts. Fasten the Angle braces (A)
to the Corner Posts using one 5/16 x 3" Lag Screw and Flat
washer in each Angle brace (A).
note: The Stringers have been omitted from the illustration
for clarity.
