Assembly
Pine Skybox
19690-100 Rev J (06-16)
© Copyright 2005, Creative Playthings
Page 15
ASSeMbly InStRuCtIonS
illustration #26
illustration #27
SteP 15 - Side tent Supports:
Fasten the Side Tent Supports (k) to the rear Gym
Corner Posts using two 5/16" x hex bolt Assemblies
each. The bolts should go through the holes where
the reat end Tent Support was formerly fastened. The
Large diameter holes should face toward the Gym.
Attach an Access Ladder bracket to one of the Side
Tent Supports (k) using a 5/16 x 1-1/2" hex bolt
Assembly. Leave the connection loose. Swing the
Access Ladder bracket until one face rests against
the Side Wall Support on the Gym, as shown
in the detail illustration. make sure that
the Side Tent Support is level. mark the
center of the hole on the Side Wall
Support using a pencil. drill a 1/4" x
2-1/2" pilot hole at the pencil mark.
Fasten the Access Ladder bracket
using a 5/16 x 3" Lag Screw and Flat
Washer. Repeat with the other Side
Tent Support (k).
tent Roof Gym only
SteP 16 - tent Post:
Center the Tent Post (L) between the two rear Gym Corner
Posts. Slide the Tent Post (L) into place fitting the notches
over the Short end Wall Support (v) and the Platform
Support (Z). make sure that the Tent Post is centered and
plumb.
With a pencil, mark the position of the holes in the Tent
Post on the Short end Wall Support (v) and the Platform
Support (Z). The pencil marks should be approximately
25" apart. drill a 3/8" diameter hole through the Short end
Wall Support (v) and the Platform Support (Z) at the pencil
marks.
Fasten the Tent Post (L) to the Short end Wall Support
(v) and the Platform Support (Z) using two 2-1/2" hex
bolt Assemblies. Secure the bottom of the Tent Post (L)
using two #8 x 2-1/2" Wood Screws from below the Gym
Platform boards.
j
Gym Corner
Post
K
K
Access ladder
bracket
Many parts are omitted from this
illustration; most notably the Side
Wall Supports for the Gym
Side Wall Support
l
V
Z
