Assembly
Pine Skybox
19690-100 Rev J (06-16)
© Copyright 2005, Creative Playthings
Page 9
ASSeMbly InStRuCtIonS
illustration #10
illustration #11
Assembly note:
This model of the Skybox can be installed on the Williamsburg iii or the Lexington iii. This Skybox will fit on a
set with a Tent or Wood Roof. Some steps of the installation differ from the Tent set-up to the Wood Roof set-up.
These differences are indicated by caption, as shown in step one. These instructions assume that the Skybox will
be attached to the rear of the Gym. Please review all instructions before attempting assembly.
SteP 1 - Component Removal:
A number of parts on the Gym need to be removed for assembly. Some of these items will be re-installed later. All extra parts
reamaining after assembly should be saved in case of future repairs. Retain all hardware, it may be required for assembly.
tent Roof Gym
Wood Roof Gym
tent
end tent
Support
tent Pipe
Sandbox end
Sandbox Seat
tent Pipe
tent Pipe
end Wall
Support
Rear Wall
Slats
Sandbox end
Sandbox Seat
Rear Wall
Slats
tent Post
tent Roof Gym:
Loosen the end Tent Support at the rear of the Gym,
Remove the side Tent Pipes and the Tent. Remove the
screws that hold the center Tent Pipe and then remove
the center Tent Pipe. un-bolt the rear Tent Post. Remove
the six Wall Slats across the rear of the Gym and remove
the rear end Tent Support. Remove the Sandbox Seat
and Sandbox end at the rear of the Gym.
The Tent, Tent Pipes and Sandbox Seat will be re-installed.
The Wall Slats will be re-used.
Wood Roof Gym:
Remove the six Wall Slats across the rear of the Gym and
remove the rear end Wall Support. Remove the Sandbox
Seat and Sandbox end at the rear of the Gym.
The Sandbox Seat will be re-installed. The Wall Slats will
be re-used.
When mounting the Skybox to a Gym that is to have a Clubhouse or Fun deck do noT remove Sandbox end, see page 19.
