Create RETRO M, User Manual

Page: 8 / 48

8 ENGLISH
INSTALLATION
INSTRUCTIONS
The temperature setting allows you to adjust it according to your needs:
• Adjust the temperature before tasting red wines: recommended temperature 16-17 °C.
• If the ambient temperature is higher or lower than the recommended temperatures, this
will have a negative impact on its performance. For example, placing the drive in an ex-
tremely hot or cold location can cause variations in the drive's internal temperature.
• The internal temperature can vary depending on the location of the bottles, at the top, mid-
dle or bottom.
• Adjustment may be necessary depending on the ambient temperature.
• Feel free to leave a thermometer inside the winecooler for regular monitoring.
• This winecooler is designed to hold a maximum of 15 standard size wine bottles (75cl) with-
out shelves and 12 standard size wine bottles (75cl) with shelves.
• Temperature setting:
• The keys and allow you to increase or decrease the temperature in 1°C increments
(temperature range is 4 ~ 22°C)
• The button allows you to turn the interior lighting on and off.
• In RETRO WINECOOLER:
• Press the button 6 seconds to switch from on to off.
• When you press the keys and for at least 2 seconds, get the temperature reading
in Fahrenheit or Celsius.
• After you set the temperature, the screen will return to displaying the temperature in the
refrigerator, but it might return to the point you have set gradually.
Before putting your winecooler into operation:
• Remove all components from both internal and external packaging and verify that none
of the parts are missing.
• Before the first use, it is recommended to wait at least eight hours before connecting the
winecooler so that the oil can return to the compressor. Check that the water reservoir is
in place before plugging in the unit.
• Clean the internal surfaces of the unit with a soft cloth and warm water.
• Place your unit on a floor strong enough to support the weight of the fully loaded unit, if
on carpet place a wooden board between them. The space in which the product is located
must be at least 1 m3 per 8 g of refrigerant.
• Make sure the unit is level by adjusting the front feet under the unit. Make sure that the
winecooler rests on its legs in a stable manner. Do not tilt the winecooler more than 45º
from vertical when moving it.
• Install the appliance away from direct sunlight, which can damage the unit's cladding, and
away from heat sources which can increase its power consumption.
• Do not use excessive force anywhere. The metal rails on the bottom can have sharp edges,
so always unpack and handle with care. Carefully place the product to avoid scratching
the floor.
• This unit is designed for indoor use only.
• Caution: Make sure the unit is kept away from any substance that can cause combustion.