14
Crazy3DPrint CZ-300
• Extruder Motor & Z-Motor (Blue & White Marking)
1) Plug the 3-pin white housing into the Z-sensor socket.
2) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.
INSTALLATION
SECURING PRINT BED CABLE
(1) Take out the platform clip; following install the cable with it and clip back to the print bed.
INSTALLING FILAMENT TUBE
Accessory Preparation
Filament Tube (*1)
2
(1) Fully insert the filament tube into the extruder motor and the extruder module.
