13
Crazy3DPrint CZ-300
INSTALLATION
• Y-Motor & Y-Sensor (Yellow Marking)
1) Remove the screw from the Y-motor plastic cover; following place the ground wire ring under the plastic cover and
insert back the screw as well as tighten it.
2) Plug the 6-pin yellow housing into the Y-motor socket; following plug the 3-pin yellowing housing into the Y-sensor
socket.
The cable should be placed underneath the lower frame to prevent accidental pulling by the rod and the
print bed while printing.
• Extruder Motor & Z-Motor (Blue & White Marking)
1) Plug the 6-pin blue housing into the extruder motor socket; following plug the 3-pin white housing into the z-motor
socket.
2) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.
