Crane BARNES 6SE-EHA Series, Installation And Operation Manual

Page: 19 / 22

START-UP REPORT
FOR SUBMERSIBLE PUMPS
This report is designed to insure the customer that customer service and a quality product are the number one
priority with Crane Pumps & Systems, Inc. (CP&S). Please answer the following questions completely and as
accurately as possible. Mail this form to:
In U.S.A. Send To: In Canada Send To:
CRANE PUMPS & SYSTEMS, INC. CRANE PUMPS & SYSTEMS, INC.
ATTN: WARRANTY SERVICE GROUP ATTN: SERVICE MANAGER
420 THIRD ST. / P.O. BOX 603 83 WEST DRIVE, BRAMPTON
PIQUA, OHIO 45356-0603 U.S.A. ONTARIO, CANADA L6T 2J6
REPORTS THAT ARE NOT RETURNED CAN DELAY OR VOID WARRANTY.
Pump Owner’s Name
Address
Location of Installation
Person in Charge
Phone
Purchased From (Crane Pumps & Systems Representative/Distributor)
Pump Model Serial No.
Part Number
Voltage
Phase Hertz Horespower
Rotation: Direction of Impeller Rotation (Use C/W for clockwise, CC/W for counter-clockwise)
Method Used to Check Rotation (viewed from bottom)
Does Impeller Turn Freely By Hand:
YES NO
Condition Of Equipment GOOD FAIR POOR
Condition Of Cable Jacket GOOD FAIR POOR
Resistance of Cable Jacket GOOD FAIR POOR
Resistance of Cable and Pump Motor (measured at pump control)
Red-Black
Ohms, Red-White Ohms, White-Black Ohms
Resistance Of Ground Circuit Between Control Panel and Outside of Pump Ohms
MEG Ohms Check of Insulation:
Red to Ground
White to Ground Black to Ground
Condition of Equipment At Start-Up: Dry Wet Muddy
Was Equipment Stored: Length of Storage:
Describe Station Layout
Liquid Being Pumped
Debris In Bottom of Station?
Was Debris Removed In Your Presence?
Are Guide Rails Exactly Vertical?
Is BAF Stationary Installed Level?
Liquid Level Controls: Model
Is Control Installed Away From Turbulence?
Operation Check:
Tip Lowest Float (Stop Float), All pumps should remain off.
Tip Second Float (and Stop Float), One pump comes On.
Tip Third Float (and Stop Float), Both pumps on (alarm on simplex).
Tip Fourth Float (and Stop Float), High Level Alarm On (omit on simplex).
If not CP&S level controls, describe type of controls.
Does liquid level ever drop below volute top?