F-2.2) Reassembly:
Lightly oil (
DO NOT
use grease) outer surface of stationary
member (20A). Press stationary member (2020 firmly into
mounting plate using a seal pusher, nothing but the seal pusher
is to come in contact with seal face (see Fig. 4).
IMPORTANT !
DO NOT HAMMER ON THE SEAL PUSHER- IT WILL
DAMAGE THE SEAL FACE.
Make sure the stationary member is in straight and that the
rubber ring is not out of it’s groove. Lightly oil (
DO NOT
use
grease) shaft and inner surface of bellows on rotating member
(20B) see Fig. 5. With lapped surface of rotating member (20B)
facing inward toward stationary member (20A), slide rotating
member (20B) onto shaft using a seal pusher, until lapped
faces of (20A) and (20B) are together. (see Fig. 3).
IMPORTANT !
IT IS EXTREMELY IMPORTANT TO KEEP SEAL FACES
CLEAN DURING ASSEMBLY. DIRT PARTICLES
LODGED BETWEEN THESE FACES WILL CAUSE THE
SEAL TO LEAK.
Place spring (20C) over shaft and in place on rotating member
(20B), making sure it is seated on retainer and not cocked or
resting on bellows tail. Slide retaining ring (20B) over shaft and
let rest on spring (20C). Assemble impeller and volute as
outlined in paragraph F-1.2.
WARNING !
DO NOT DISASSEMBLE THE RELIANCE MOTOR IN
ANY WAY, EXCEPT FOR OUTER SEAL, AS THIS WILL
VOID WARRANTY.
F-3) Motor , Cables & Inner Shaft Seal Service
The Submersible pump motor is manufactured by Reliance®
Electric Co. and must be serviced and repaired by Reliance
approved service centers only. For lead reconnection
information, contact Reliance Electric Co., giving motor serial
number.
WARNING !
ALL REPAIRS, OTHER THAN LEAD RECONNECTS
AND OUTER SEAL REPLACEMENT, SHALL BE
PERFORMED BY AN AUTHORIZED RELIANCE
SERVICE FACILITY. ANY OTHER REPAIRS
PERFORMED BY THE CUSTOMER OR NON-RELIANCE
SERVICE FACILITIES NEGATES THE MOTOR
WARRANTY.
PUMP END
(OUTBOARD END)
MOTOR END
(INBOARD END)
Seal
Assembly
(20)
Mounting Plate
(Motor)
Stationary
(20A)
Rotating
Member (20B)
Spring (20C)
Retaining
Ring (20D)
Fig. 3
Motor Mounting
Plate
SEAL PUSHER
Stationary
Member (20A)
Fig. 4
Reliance Motor
Stationary (20A)
Rotating Member (20B)
Seal Pusher
Fig. 5
10
Summary of Contents for BARNES 6SE-EHA Series
Page 13: ...Fig 6 320 FRAME 250 FRAME 13 ...
Page 14: ...Fig 7 14 ...
