CAUTION:
Wear a dust mask if blowing
creates dust which might be inhaled.
CAUTION:
To reduce the risk of hearing
damage, wear ear protection when using the
vacuum/blower for extended hours or in
confined space.
5
ENGLISH
INSTALLING DISPOSABLE FILTER BAG
WARNING:
To reduce the risk of injury
from accidental starting, unplug power cord before
emptying the dust tank.
EMPTING THE TANK
NOTICE:
To reduce the risk of damage to the
vacuum, do not run motor with float in raised position.
WET PICK-UP
1 . Remove the cartridge filter and replace it with
foam filter when you do wet pickups.
2 . This wet/dry vac is equipped with a float mechanism
which will rise automatically to cut off the airflow when
the liquid in the tank reaches a predetermined level. When
this happens, turn off vac, unplug the power cord, and
empty the dust tank. You will know that the float has
shut the airflow off because the suction ceases and
the motor noise becomes higher in pitch due to
increased motor speed. The liquid capacity may vary
with the rate of pickup.
The vacuum contains a blowing feature. Follow the steps
below to use the vacuum as a blower .
1 . Locate blowing port on the vacuum.
2 . Insert the buckle end of the 7 ft x 1-7/8 in / 2.1 m x 48 mm hose
into the blower port.
3 . Turn the vacuum "ON".
1 . Slide the cardboard collar opening firmly onto the vacuum
port deflector until it stops against the deflector wall.
2 . Position the disposable dust bag so that it is distributed
around the inside of the tank.
3 . Replace and secure the power head onto the tank.
1 . Remove the power head assembly of the wet/dry vacuum
by pulling outward on the lid clips located on each side
of the vacuum. Lift off the power head assembly.
2 . Dump the dust tank contents into the proper waste
disposal container.
WARNING:
Always wear safety eyewear
complying with ANSI Z87.1 (or in Canada CSA Z94.3)
when using as a blower.
WARNING:
To avoid injury to bystanders,
keep them clear of blowing debris.
BLOWING OPERATION
11
3
5
15
15
15
7
12
14
11
14
7
5
15
3
12
