ENGLISH
4
WARNING:
To reduce the risk of fire or
explosion, do not operate this vacuum in areas with
flammable gases, vapors or explosive dust in the air.
Flammable gases or vapors include but are not
limited to: lighter fluid, solvent-type cleaners,
oil-based paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain or gun powder.
Do not vacuum explosive dust, flammable or
combustible liquids or hot ashes. Do not use this
vacuum as a sprayer for any flammable or
combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility
vacuum can result in foreign objects being blown
into the eyes, which can result in severe eye damage.
Always wear safety eyewear complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before starting
operation.
CAUTION:
To reduce risk of hearing
damage, wear ear protectors when using the vacuum
for extended hours or when using it in a noisy area.
NOTICE:
A dry cartridge filter is necessary
to pick up dry material. If you use the vacuum to
pick up dust when the cartridge filter is wet, the
cartridge filter will clog quickly and be very difficult
to clean. If the cartridge filter gets wet, replace it
before continuing to do dry pickups.
OPERATING INSTRUCTIONS
DRY PICK-UP
1 . Pull lid latches in an outward motion, remove power
head and some accessories that may have been
shipped in the tank.
2 . Attach casters following the instructions as below:
a.
Invert dust tank, take the casters to align the tank
bottom sinking place. Press firmly until you hear a click
which indicates the casters are installed in place.
b.
Return dust tank assembly upright.
3 . Before replacing power head, refer to this manual to
ensure you have the proper filters installed for the
cleaning operation.
4 . Replace power head, and apply pressure with thumb
to each latch until it snaps tightly in place. Make
sure all lid latches are clamped securely.
5 . Insert the hose end into vacuum port of tank.
6 . Attach the extension wands to the end of the hose.
Apply slight pressure until fitting is tight.
7 . Attach one of the cleaning accessories (depending on
the cleaning requirements) on the extension wands .
Twist slightly to tighten the connection.
8 . Plug the cord into the wall outlet. The vacuum is
ready for use.
9 . Turn the unit “ON” by pressing the switch from
position “O” to position “I”. The “O” is the “OFF”
position and the “I” is the “ON” position.
1 . The filter must always be in correct position to reduce the
risk of leaks and possible damage to vac. Make sure that
the filter is completely covering the cartridge filter .
Make sure there are no gaps between the cartridge filter
and the lid. (See illustration). It is very important to
assemble the filter to the cage without allowing any
possible leaks or tears. Any leaks will allow the picked up
debris to be blown out of the blowing port and back into
the surrounding environment.
2 . When using the vacuum to pick up fine dust, it will be
necessary to empty the dust tank and clean or replace
the cartridge filter at more frequent intervals to
maintain peak vacuum performance.
UNPACKING & SET-UP SUMMARY
14
6
2
14
14
14
6
3
3
3
7
4
8
8
2
6