8
ASSEMBLY
Installing the Recoil Starter Handle
1. Remove the eye bolt and handle knob from the manual bag.
2. Place the eye bolt and handle knob on the upper handle as shown
in Figure 6. Do not fully tighten the hardware until instructed to do
so.
NOTE:
The opening of the eye bolt should face toward the back of the
snow thrower.
3. Slowly pull the recoil starter handle up towards the eye bolt.
4. Slip the recoil starter rope into the eye bolt from the back side of
the snow thrower. See Figure 6.
5. Securely tighten the eye bolt and handle knob.
2. Remove the screws in the chute base. See Figure 4.
3. Align the holes in the chute base with the holes in the lower chute
and secure with the previously removed screws. See Figure 5.
Figure 4
Figure 5
Eye Bolt
Handle Knob
Recoil Starter Handle
Figure 6
