4
OPeRAtING INStRUctIONS
WARNING:
Risk of Bursting
. Too much air pressure causes a hazardous risk of bursting.
Check the manufacturer’s maximum pressure rating for objects being inflated.
cAUtION:
The air hose does not detach from the inflator attachment. Do not attempt to
service or modify the air hose.
WARNING:
Shock hazard.
Under no circumstances should this product be used near water.
WARNING:
Risk of lacerations or burns.
Do not touch work piece or accessory immediately
after operating the tool. They can become very hot. Handle carefully. Always allow accessories and
work piece to cool before handling.
WARNING:
to reduce the risk of injury
,
turn off and remove battery from tool or disconnect plug
from power source before making any adjustments or removing or installing attachments or accessories.
Remove any accessory from the attachment before removing or installing the attachment.
IMPORtANt:
Refer to Power Unit instruction manual before operating this tool for all safety warnings
and details on installing and removing attachments.
INflAtING
• To switch the tool on, press the variable speed switch on the power unit. The tool speed depends
on how far you press the switch.
• To switch the tool off, release the variable speed switch.
NOte:
This attachment only operates in the forward direction, the forward/reverse slider of the
Power Unit should not be able to be switch to reverse.
vAlve ADAPtOR
• Position the lever (A1) of the valve adaptor straight up.
• As shown in
figure A
, push the valve adaptor down over the
threaded section of the valve stem, or over one of the nozzles
provided with your inflator.
• When the adaptor is down all the way, press the lever down to
lock it in place.
• To release the adaptor from valve stem or accessory nozzles, lift
the lever straight up and pull the adaptor off.
• Operate your Inflator only with the nozzles included.
• Make sure that the universal valve adaptor lever is firmly locked
down in place before turning the Inflator on.
NOte:
Many inflatables, especially air mattresses, have an internal flap that prevents air loss during
inflation. Unless this flap is displaced by the nozzle the mattress will not inflate. Push the nozzle
firmly into the valve to ensure that you push this flap out of the way.
HOSe AND PReSSURe GAUGe
NOte: Never carry the inflator by the hose.
• The pressure gauge, which is located on the hose, will give a pressure reading in P.S.I. (pounds per
square inch) as well as in Bar pressure units.
• In the case of tire inflating, it is recommended that the pressure reading be verified by checking with
a separate tire gauge.
• To obtain a more accurate pressure measurement, turn the Inflator OFF when reading the gauge.
WARNING:
Do not leave inflator running unattended.
It could burst tires or other items.
A
A1
