Features
Your garage door opener is equipped with features to provide you
with greater control over your garage door operation.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the
factory to operate with your remote control, which changes with
each use, randomly accessing over 100 billion new codes. Older
Craftsman accessories are not compatible.
Accessories
MEMORY CAPACITY
Remote Controls
Up to 8
Door Controls
Up to 2 door controls.
Keyless Entries
Up to 1
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing
sensors will detect an obstruction in the path of the infrared
beam. If an obstruction breaks the infrared beam while the door is
closing, the door will stop and reverse to full open position, and
the opener lights will flash 10 times. If the door is fully open, and
the safety reversing sensors are not installed, or are misaligned,
the door will not close from a remote control. However, you can
close the door if you hold the button on the door control or
keyless entry until the door is fully closed. The safety reversing
sensors do not effect the opening cycle.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode
when the door is fully closed. The sleep mode shuts the garage
door opener down until activated. The sleep mode is sequenced
with the garage door opener light bulb; as the light bulb turns off
the sensor LEDs will turn off and whenever the garage door
opener lights turn on the sensor LEDs will light. The garage door
opener will not go into the sleep mode until the garage door
opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener
is initially plugged in; power is restored after interruption, or when
the garage door opener is activated. The lights will turn off
automatically after 4-1/2 minutes. An incandescent A19 light bulb
(100 watt maximum) or for maximum energy efficiency a 26W
(100W equivalent) compact fluorescent light (CFL) bulb may be
used.
Using Your Garage Door Opener
The garage door opener can be activated through a wall-mounted
door control, remote control, or wireless keyless entry.
When the door is closed and the garage door opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction
interrupts the sensor beam the garage door opener lights will
blink 10 times. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully
closed. The safety reversing sensors do not affect the opening
cycle.
The safety reversing sensor must be connected and aligned
correctly before the garage door opener will move in the down
direction.
Using the Door Control
Press the lighted push button to open or close the door. Press
again to reverse the door during the closing cycle or to stop the
door while it's opening.
32
