4
Read and follow all the instructions
and safety precautions in the user
manual before setup or use.
For the protection of your eyes, always
wear safety glasses, goggles or face
shield while operating the sander.
Never touch the moving sanding disc.
Keep your hands and fingers away
from the moving sanding disc. If the
work-piece is small or difficult to hold,
use work-piece holding fixture.
Always support the work-piece on the
work table against the rotation
direction of the sanding disc.
All guards must be in place while
operating the sander to avoid any
injuries.
Always feed the stock smoothly
against the rotation of the sanding
disc. Do not use excessive force while
operation.
Always sand work-pieces which are
stable and if you have any doubt about
the stability of the material, do not
sand it.
Make sure before making any
adjustments, the switch is in the “OFF”
position and the cord is un-plugged.
Never leave the sander unattended
while it is running.
Do not use the sanding discs that are
damaged or if the adhesive is not
sticking firmly. If the sanding disc comes
off during operation, it might cause
damage to the work-piece or injury to
the operators fingers.
Make sure to position the work table in a
position where the gap between the
sanding disc and the table does not
exceed 3mm.
Do not wear loose clothing, neckties,
jewelry or gloves that can get caught in
moving parts. Confine long hair and
keep sleeves above the elbow.
Make sure you have read and
understood all the safety instructions in
the manual and you are familiar with
your sander, before operating it. If you
fail to do so, serious injury could occur.
CX506 – 12" DISC SANDER
SPECIFIC SAFETY INSTRUCTIONS
WARNING!
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions
.
