10
TEST RUN
Once you have mounted your machine, it is
then time for a test run to make sure that
the machine works properly and is ready for
operation.
To test run the machine:
Make sure you have read and understood
the instructions given in the manual.
Remove and clear away all the tools and
objects from the machine.
Rotate the disc by hand and make sure it is
not contacting the table edge.
Connect the cord to the power source and
turn ON the machine.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, shut off the
machine immediately and disconnect the
cord from the power source. Check all the
parts you have assembled, once again and
investigate to find out the problem.
If the machine runs smoothly with little or no
vibration, then it is operating correctly.
Turn OFF the sander.
Remove the switch disabling key from the
ON/OFF switch.
Try to turn ON the machine.
If the machine starts, immediately stop the
machine and unplug the cord from the
power source. Do not run the machine until
this safety feature is fixed.
If the machine does not run, it means the
switch disabling key is working properly and
test is complete.
TABLE TILT ADJUSTMENT
The table on CX506 can be positioned from
0° to 45° at any angle, for angled sanding.
To adjust the table tilt to 90° with the disc:
Disconnect the cord from the power source.
Place a machinist square with its one edge
on the table surface and the other edge
touching the face of the disc. See figure-9.
Loosen the lock levers under the table and
adjust the table so that it is perfectly
perpendicular to the sanding disc and
retighten the lock levers.
Adjust the stop bolt and tighten in position.
If you want to adjust the table to an angle
less than 90°, remove the stop bolt.
Figure-5 Table tilt
