12
MITER SANDING
To get a perfect miter, cut the work-piece
slightly longer and sand it to the desired
dimension.
To perform miter sanding:
Loosen the lock knob on the miter gauge
and adjust the miter gauge to the desired
angle.
Slide the miter gauge into its slot on the
table.
Place the work-piece on the table with one
of its surfaces against the miter gauge and
other against the sanding disc.
Now, hold the work-piece firmly with the
miter gauge and push it lightly into the
down-spin side of the rotating sanding disc.
See figure-7.
Figure-7 Miter sanding
ANGLE SANDING
The CX506 features a table which can be
positioned from 0° to 45° at any angle for
angled sanding.
To perform angled sanding:
Loosen position the table at the desired
angle shown on the scale under the table.
Hold the work-piece firmly with the miter
gauge and push it into the down-spin side
of the sanding disc with light pressure.
Figure-8 Angle sanding
WARNING!
Make sure the machine is turned off and
the cord is disconnected from the power
source before servicing and
removing/replacing any components on
the machine.
