ACQUAMARINA POOL MANUAL
pag. 21 / 21
www.cpa-piscine.it
Rev.00
–
18/11/20
XII.
Fixing the leaf skimmer
To prevent rust, all edges of cut out have to be covered by vinyl tape or rusting paint. Begin the installation of the through the wall
skimmer. Follow separate skimmer installations.
PHASE 3
–
Filling the pool with water
Before you fill the pool with water, thoroughly check to see if there are any loose screws, holes or tears in the liner. Fill the pool
until it is half-
way across the skimmer box opening or to the maximum water level or a minimum of 15cm (6”) from the top of the
pool wall (see diagram 44) to make sure water is entering the skimmer box opening.
WARNING
To avoid collapse, never leave the pool without water in it.
Diagram 44
WARNING
The filter pump must be switched off if there are swimmers inside the pool! Follow assembly instructions in the sand filter pump
combo manual.
PHASE 4
–
Pool maintenance
1.
Always keep your pool clean and apply the correct pool chemicals. Unsanitary water is a serious health
2.
Maintain pool pH level between 7.2 to 7.6
3.
Ask your dealers advice first if you want to modify your filtration system
4.
Clean the PVC liner regularly with non-abrasive brushes or venturi vacuum cleaner
5.
Turn your filtration system on at least one day before using the pool. Allow enough time to ensure the pool water is completely
filtrated before use
6.
Make sure the water level is 15cm (6”) from the top
.
Note
•
The information contained in this document may vary at the discretion of the editor, without prior notice, together with the changes to the product in
question in this document: it will be the customer's responsibility to check the persistent correspondence of the product to the information sheet when
placing the order.
•
Any technical diagrams reproduced in this document have a purely informative value and are not valid for regulatory purposes.