ACQUAMARINA POOL MANUAL
pag. 12 / 21
www.cpa-piscine.it
Rev.00
–
18/11/20
5.
Place the bottom metal piece between the joins of the rails with the triangular end pointing out from the pool wall (diagram
19).
6.
Place the inside bottom protector
over the steel belt and screw into
the horizontal side beam.
Note
: ensure the PVC sleeve covers
the steel belt to prevent damage or
rust effecting the pool (diagram 20)
CAUTION: Wear protective gloves when handling metal wall
7.
Place the metal pool wall with the skimmer hole at the
top, onto a piece of cardboard, ply wood or ground
during installation. Note: Position the pool wall’s
skimmer cutout in the same location to where your
electricity supply will be to power the filtration system
(diagram 21)
Diagram 21
8.
Rest the end of the pool wall in the side bottom metal piece between the gap in the side rail. Make sure the prepared
location is not prone to constant windy conditions. Continue unrolling and placing the bottom edge of the pool wall into
the rails until the full length of the wall is sitting in rails (see diagram 22).
Diagram 20
Diagram 19
Inside of pool
Outside of pool
Leaf skimmer cut
out
Diagram 22
