CP Plus CP-UNR-1xxQ1 Series, User Manual

Page: 158 / 189

150
Parameter Function
Record
latch System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
SMS If you check the box here, system can send out a message to the
specified mobile phone when an alarm occurred.
Send
email If you enable this function, system can send out email to alarm the
specified user.
Show
message Once you check the box to enable this function, system can display the
alarm icon on the right of the channel name at the local end.
7.4.4.3 Alarm I/O
Here you can search alarm output status. See Figure 7-47.
Figure 7-47 Alarm I/O Configuration
Important
The alarm output port should not be connected to high power load directly (It shall be less than 1A)
to avoid high current which may result in relay damage. Please use the co contactor to realize the
connection between the alarm output port and the load.
Please refer to the following sheet for detailed information.
Parameter Function
Alarm output
The alarm output channel may vary. The interface here is for
reference only.
Please click the corresponding number and then click the trigger
button.
Trigger Enable/disable alarm output.
Please note once you activate an alarm manually, you need to
click the output channel number again and then click trigger button
to disable it. Otherwise the alarm cannot be cancelled.
Refresh
Search alarm output status.