4
.
Operation of SPA Pump
3.5 Replacement pumps
4.1: You must ensure the water in the spa matches the water line
printed on the spa wall. Never dry-run the power pack.
4.2: Control panel
FILTER Key - On-off key for the filtration system. Press this key, and
the filter pump will start working and the red indicator lamp will be
on. Press again the pump will stop working and the lamp will be off.
When the FILTER PUMP has worked for 168 hours, the letters ‘FC’ will appear
on the display screen, accompanied by a warning tone. At that time, the
indicator lamp for the key of filtration system will be on but the filter pump
will actually not work. The indicator lamp for the key of heating system will
be off and the heating system will not work. Only by pressing the key
‘FILTER’ again can the indicator lamp for the key of filtration system be off. At
that time, the letters ‘FC’ on the display screen will disappear and so will the
warning tone. Actual water temperature will be displayed. All keys return to
normal working status.
‘FC’ and the warning tone are to remind the user to clean or replace the filter
element.
Bubble Key - On-off key for the bubble system. Press this key and the
air pump will start working and the red indicator lamp will be on.
Press again and the bubble system will stop working and the lamp will
be off. The bubble system will stop automatically after working for 20
minutes. If you still need bubble function, you have to wait for 10 minutes
and then pres
s the “bubble”
key again.
During the time period which the bubbling function has been started and
worked for 15 minutes, bubbling can be stopped or started. During the time
period that the bubbles have been worked for 15 minutes and stopped,
bubbling can be stopped but not be started. The re-starting of bubbles should
wait for 10 minutes. When the bubbles have been on for 20 minutes and
stopped, the function cannot be started again within 10 minutes.
HEATER Key - On-off key for the heating system. Press this key the
heating system will start working and the red indicator lamp will be
on. Press again and the heating system will stop working and the
lamp will be off.
When pressing down the key ‘HEATER’, the heating system will start working
and the red indicator lamp will be on. At the same time, the red indicator
lamp of the key FILTER will also be on and the filter pump will start working,
too. This is a normal phenomenon required by the design.
When the preset temperature has been reached, the heating system will stop
working while the heating indicator lamp will not turn off. The filter pump will
not stop working and the filtration indicator lamp will be on. When the water
temperature falls to 2 below the preset temperature, the heating system will
start working automatically and so will the filter pump. The filtration indicator
lamp will be on.
NOTES: For your safety, don’t press the buttons of bubble and heat at
same time.
TEMPERATURE Key – Key for setting temperature. Press increasing
Key or decreasing Key and the numbers on the display screen will
start flashing, and the keys for increasing or decreasing temperatures
can be pressed to set the temperature. When settings are finished,
Default temperature is 38°C(100
℉
), and temperature can be set within
the range of 20-40°C(68-104
℉
).
------ Key for increasing temperature
------ Key for decreasing temperature
Before replacing the pump, cover the
inlet and outlet on the inner wall of the
pool with a backwater cover to prevent
the water from flowing out, as shown in
figure 11
11
12
13
