Costar CCI2525R, Installation Manual

Page: 9 / 20

Part 1 – Introduction
9
Main Unit
Front
1
2
4 5 6 78 3
Back
1
2
4 5 6 78 3
1
Status LED
2
Factory Reset Switch
3
Power
4
Network Port
5
SD Memory Card Slot
6
Video In
7
Alarm I/O
8
Audio I/O
•
Status LED
-
Power LED:
Indicates the system's operating
status. For more information, refer to the
LED
Status Indications .
-
Network LED:
Indicates the network connection
status. For more information, refer to the LED
Status Indications .
•
Factory Reset Switch
Restores the camera's default factory settings. For
more information, refer to the
Factory Reset .
•
Power
-
DC12V -/+
: Connect the two wires of the power
adapter to these ports. Be careful not to cross
the + and - wires. Booting will commence once
connected to a power supply.
• Please wire within 3m(118") indoors for stable
power supply when installing the adapter.
• It is recommended to use only one of the 12V
adapter power or PoE power. Using two power
sources at the same time may limit some
functions of NVR.
• Network Port
Connect a Cat5e cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
INIT operation manual
.
• SD Memory Card Slot
Pull on the connection cover and then insert a
microSD memory card into the slot. (An SLC (Single
Level Cell) or MLC (Multi Level Cell) card by SanDisk
or Transcend is recommended)
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
• An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
• Video In
Connect the camera cable. Connect a Cat5e cable
with an RJ-45 connector to the camera mudule.
The recommended connection length between the
camera module and the main unit is up to 30m. The
recommended cable connection standard between
the camera module and the main unit is TIA / EIA-
568-B.
The product could be damaged if used with the
crossover cable.