COSMOGAS AGUADENS Series, Installation, Operating And Maintenance Manual

Page: 38 / 72

38 AGUADENS
COSMOGAS
6.1 - Operating
Before starting the appliance up, it is necessary to carry out
the following.
6.1.1 - User instructions
Instruct the user regarding correct use of the appliance and
the plant in general. In particular:

Give the installation and user manual and all
documentation contained in the packaging to the user.

Instruct the user concerning the special measures for the
exhaust of burned gases, informing them that they must
not be modified.

Inform the user regarding the correct adjustment of the
temperatures settings.
6.1.2 - Filling the condensate drain siphon
The siphon found inside the appliance (see figures 3-2 and 3-4
detail “40”), must be filled with water to create the water head
able to prevent the fumes escaping from pipe “F” in figure 5-9.
Proceed as follows to do this:
(refer to figure 6-1 for models 16 and 22 or figure 6-2 for
model 37)
1.- loosen the screw “E”;
2.- remove the lid “D” and the gaskets “C”;
3.- introduce a rubber hose into the opening “B” ( do not
confuse with “A”) and the other end of the hose into the
funnel;
4.- use the funnel to slowly pour about 200 cm³ (a glass) of
water;
5.- re-mount everything in reverse order.
6 - OPERATING
Figure 6-1 - Filling the condensate drain siphon on
models 16 and 22
ATTENTION !!! If the appliance remains off for
more than 3 months, the siphon must be filled again as
explained above.
6.2 - General recommendations
regarding the supply of gas
For commissioning of the appliance, have a professionally
qualified technician perform the following checks:

That the appliance is powered by the type of fuel for
which it is set-up.

That the gas supply pressure (with appliance operating
and at a standstill) is within the maximum and minimum
values indicated in the table in section 9 at the end of the
manual.

That the supply plant has all safety and control parts
envisioned by the current national and local Standards.

That the exhaust flue terminal discharge terminal and
the combustion agent air intake terminal are free from
any obstruction.

That the exhaust flue terminal and combustion agent air
intake terminal are positioned outside the building.

That the condensate drain connection is connected.
ATTENTION !!!
If you smell gas:
A - Do not switch on any electric device, telephone
included or any object that can cause sparks;
B - Immediately open doors and windows causing
a current of air that quickly cleans the gas from
the room;
C - From another room, or from a neighbour’s,
immediately call a professionally qualified
technician or the gas supply company. Call the
Fire Service if the former are not available.
B
D
B
D
020008.01.023
Figure 6-2 - Filling the condensate drain siphon on
model 37