Cosen SH-710LDM, Instruction Manual

Page: 41 / 127

4 ‐ 7
This button only works when the machine is switched to setting mode “ ”
8. Saw bow up button
When this button is pressed, the saw bow rises until the operator lets go of the button or until the
saw bow reaches the highest position and touches the upper limit switch. Under cutting mode, press
and hold this button for three seconds and the saw bow rises automatically to its highest position.
While pressing the saw bow up button can stop the running blade, please still use the
emergency stop button in an emergency.
9. Saw blade start/stop buttons with built ‐ in lamp (CE model only)
The upper button is saw blade start button and the lower button is saw blade stop button. When the
upper button is pressed, the built ‐ in lamp comes on and saw blade starts to cut. Press lower button
to stop cutting. The blade will start only when the sawhead swivel LOCK/UNLOCK switch is turned to
locked position and under cutting mode.
10. Setting/cutting mode switch (CE model only)
This selector switch provides two modes to choose from: setting and cutting. To switch between
these modes, a key is required. Please keep the key at a safe place and do not lose it.
Setting mode The setting mode provides a safe environment while adjustment prior to
cutting is conducted or when machine maintenance is required. Cutting is
not allowed in the setting mode.
Cutting
mode
Cutting is allowed only in cutting mode.
11. Blade speed control knob
Blade speed is controlled by the inverter located under the workbed. Turning the knob clockwise
increases the blade speed.
12. HMI touch screen
Please refer to later section for detailed introduction.