Cosen SH-460M, Instruction Manual, Page: 49 / 96

4 ‐ 13
ADJUSTING COOLANT FLOW
Step 1 – Press the power on button to start the saw blade drive motor.
Step 2 – Lower the saw bow.
Step 3 – Use the flow control valve (shown below) to adjust the amount of fluid flowing to the cutting
area.
Adjust the flow amount if you observe the following changes to the chips generated from
cutting.
If the chips are sharp and curved, increase the
coolant flow amount.
If the chips are granulated, decrease the coolant flow
amount.
INSTALLING MATERIAL STOP BRACEKT
Fig 9 Material Stop Bracket
Step 1 ‐ Install the depth bar (Fig 9, #2) and tighten the set
screw (Fig 9, #1). (The depth bar is taken off from
the machine base during transit for safety reason.
Step 2 ‐ Lift the saw bow and clamp material securely with
vise.
Step 3 ‐ Lower the saw bow to allow about 1 mm
clearance between saw blade teeth edge and the
top of the material. Then measure your desired
cutoff length.
Step 4 ‐ Loosen the fastening bolt (Fig 9, #3)
Step 5 ‐ Slide and position the stopper (Fig 9, #6) so that
the end of stopper faces the direction of the front
end of the material. Then tighten the stopper
handle (Fig 9, #5) to fix the stopper in the bracket
(Fig 9, #4).
Step 6 ‐ Move the stopper bracket (Fig 9, #4) toward the
workpiece so the stopper end just touches the
front of the material, then tighten the fastening
bolt (Fig 9, #3).