SRP 003-485 • Issue 6 • October 2006
Page 25
SCF-6 Canister and Inline Splice Closures
Figure 39 — End View of Gasket Orientation
Figure 40 — Lubricate Gasket
Step 4
Push the joiner clip together until
both parts of the clip latch. The clip
must snap audibly before it is secure.
Tension the sealing gasket slightly at
the closing point to make sure that
both ends of the gasket are properly
aligned (Figure 38).
Figure 38 — Gasket Profile
Step 5
Place the sealing gasket into the end
cap channel. Make sure the clip is
always on top of the sealing gasket
(Figure 39).
IMPORTANT:
Position the clip on the gasket
away from the seam where the
end cap halves are joined together
as shown in Figure 39. Insert the
joining point of the sealing ring
first and hold tight so that no
tension is applied to this area.
Step 6
Apply one third tube of
lubricant to the top of the end
cap gasket (Figure 40).
Step 7
Repeat steps in section 5.12.1
for the end cap at the other end
of the closure.
KPA-0482
KPA-0650
KPA-0651
Clip
Clamping Bar
End Cap
