Standard Recom m ended Procedure 003-1002-BEN | Issue 4 | January 2019 | Page 17 of 26
Figure
24 — Insert Adapt er Panels int o Rear of Housing
4.10.2 Connecting
MTP
®
Jumper, Harness, or Extender Trunk to Front of MTP Adapter Panels
NOTE:
All MTP® harnesses and jumpers are manufactured with MTP PRO connectors. Refer to the MTP PRO
instruct ions in the related literature section for details on how to use the MTP PRO
eld tool.
CAUTION:
When removing the trays, position yourself in the center of the rack and use both hands to
pull the tray out .
CAUTION:
Do not exert excessive force on the panel. Damage to the trunk cables may occur.
Step 1:
Open housing front door and pull out tray. Ensure there is enough
bre slack in the rear of the
housing to allow for this movement.
Step 2:
Remove dust caps from the front of the MTP adapter in the panel, if applicable, and the MTP
connector of the harness, jumper, or t runk. Clean the connector and adapter w ith the MTP cleaning
tool (p/ n 2104466-01). Follow instructions provided w ith the tool.
Step 3:
M ate the connectors in the adapters (Figure
25). If MTP adapter is equipped w ith shutter, low er the
shut ter
rst , then mate the connectors.
Step 4:
Route the connected cables, half to the right and half to the left side of the housing. Do NOT cross
cables in opposite directions. Store the cables or legs in the
bre clips at the front of the tray. Close the
tray.
Figure
25 — Route Harness Cable
