Standard Recom m ended Procedure 003-1002-BEN | Issue 4 | January 2019 | Page 14 of 26
Figure
19 — Inst all EDGE8™ St andard Module
4.8 Inst all EDGE8™ Port Breakout M odules
4.8.1
Int o EDGE8-01U-SP, EDGE8-02U, and EDGE8-04U Housings
Step 1:
Starting w ith low er right corner (Tray 1, slot A), insert port breakout module from the rear until it locks
into place. Load all trays from right to left, bottom to top in the housing, as seen from the back.
Step 2:
Loop slack as show n in Figure
20, leaving enough slack to pull out t rays w ithout violating the
minimum bend radius.
Step 3:
Repeat for all modules.
Step 4:
Loosely capture
bre slack with hook-and-loop st raps, if desired (Figure
20).
Figure
20 — Inst all EDGE8™ Port breakout module
