Cormach LIGRO, Use And Maintenance Manual

Page: 37 / 157

36 Operator's manual
Ligro - Ligro GT
- Assemble the column guard 2 and lock
it with the screws and washers L.
- Fit the hose connector of the tank 4 into
hose Q, fasten the tank 4 to the machine
with nuts and washers R, and tighten the
clamp O onto the hose Q (
GT version only ).
- Open the bead breaker arm Z.
- Insert the spacer pad U on the bead breaker
cylinder pin V, re-close the bead breaker
arm by making the bead breaker cylinder
pin pass through the adjustable block.
- The T nut is to be screwed on to bead
break cylinder pin V only when the ma-
chine is installed and hooked up to the
compressed air line. Tighten the nut T
until P is 3-4mm.
it from falling and getting damaged.
Assemble the different parts of the ma-
chine (Fig. 2):
- Remove the side cover.
- Insert the air pipe G, into hole A behind
the column tilting cylinder.
- Assemble head 1, insert pin B into hole C
and lock it with the screw and washer D.
- Insert pin E into hole F and in the U-bolt
F1 of the column tilting cylinder and lock
it with ring M.
- Connect pipe G to the intermediate union
connected to the column lifting valve H.
- Assemble the box with pressure gauge
3 on column 1 and lock it with the screw
and washer S.
B
C
P
T
V
U
Z
E
M
F
D
A
F1
G
H
R
Q
O
L
D
G
S
2