Cormach GEO 10, Service Manual

Page: 29 / 44

Technical service manual
GEO 10
29
2. Select “Channel” in section “PC Radio”.
3. Press the “Check” button in section “Radio PC”. The configured “Channel” is read.
Write (Configuration)
After the channel is read as outlined in paragraph “Read” above, it is possible to write
data (Configuration) to the radio module.
1. Select the desired “Channel” among available channels in section “Radio PC”.
2. Press the “Set” button in section “Radio PC”.
Data is written to the selected “Channel”.
3. Wait for the message confirming that data was written successfully.
4. Press the “OK” button
5. Perform a reading operation of the configuration of the radio module to ensure that
the procedure was completed successfully.
Standard programming (Standard configuration)
This procedure is used when the native configuration (factory programming) of the
radio module needs to be restored.
After the channel is read as outlined in paragraph “Read” above, it is possible to write
data (Configuration) to the radio module.
1. Press the “STANDARD PROGRAMMING” button located in section “Radio PC”.
2. Wait for the message confirming that data was written successfully.
3. Press the “OK” button.
4. Perform a reading operation of the configuration of the radio module to ensure that
the procedure was completed successfully.
“Channel” must be set to 40.
RADIO MEASURING HEADS (SENSOR): Radio channel read
and write operations
Read
1. Connect all measuring sensors (heads) to the central unit.
2. Press “OK” or the radio board button (figure 22).
3. Go to section “Radio Sensor”.
4. Select “Channel”.
5. The “Check” button in section “Radio Sensor”.
The configured “Channel” is read.
Write (Configuration)
After the channel is read as outlined in paragraph “Read” above, it is possible to write
data (Configuration) to the radio modules.
1. Select the desired “Channel” among available channels in section “Radio Sensor”
(set the same channel as for the PC radio module (Central Unit).
2. Press the “Set” button in section “Radio Sensor”.
Data is written to the selected “Channel”.
3. Wait for the message confirming that data was written successfully.
4. The “OK” button.
5. Perform a reading operation of the configuration of the radio modules to ensure that
the procedure was completed successfully.