Corghi MONSTER AGTT, Operator'S Manual

Page: 61 / 218

Operator's manual MONSTER AGTT 61
UK
SERVICE
MODE Flashes slowly Flashes
upon arrival
of the com-
mands On
steady if the
cable
is con-
nected;
otherwise off Variable
messages Technical
service
personnel This operating
mode includes the
global correction
Setting and Calibra-
tion programmes�
FACTORY
MODE Variable
status based
on the com-
mands given Flashes
upon arrival
of the
commands On
steady if
the cable
is con-
nected;
otherwise
off Variable
messages Factory
personnel
Table 1 – Operating modes
DISPLAY SIGNAL AND ERROR TABLE
During normal mode, some errors could occur that are described in table 2� The error
code is shown on the display� Some errors prevent some machine automatisms from being
used (i�e� errors E00 and E01) or cause them to stop early (i�e� error E11)�
Pressing the Clear key on the control panel cancels the error code on the display but if
the cause of the error is not removed and the command that generated it is repeated,
the message will reappear
ERROR # MEANING ACTION
E00 No calibration data Calibrate the machine� If
the error remains replace the
board CPU-RX2�
This signal appears also
when a new board is
installed�
E01 No signal on analogue channel
#1 (radial movement measure-
ment potentiometer)� Check the connection of the
potentiometer and its condition�
If the error persists contact
technical assistance�
E02 No signal on analogue channel
#2 (channel currently not used)
E03 No signal on analogue channel
#3 (channel currently not used)
E04 No signal on analogue channel
#4 (analogue laser for the Side
To Side) Check the connection of the
laser and its condition� Check
that the glass on the front of
the laser is not dirty� If the error
persists contact technical
assistance�