Corghi MONSTER AGTT, Operator'S Manual

Page: 51 / 218

Operator's manual MONSTER AGTT 51
UK
This key immediately turns off all machine actuators (motors and solenoid valves) but
must not be considered an emergency button as the transmission of the command is
done via a serial connection�
FUNCTIONAL DESCRIPTION OF THE COMMAND RECEPTION UNIT VIA RADIO LO-
CATED ON THE ELECTRICAL BOARD - RX UNIT
The command reception unit, called RX unit, is housed in the tyre changer electrical
control board�
The RX unit receives the codified commands in a serial manner via a radio connection or
via cable with the TX unit located on the control lever� For a radio connection the radio
modem is used that is located outside of the electrical board on the right side�
The connection via radio toggles automatically between a connection via cable and via
radio and vice versa when the control cable is connected/disconnected�
Three LEDS (green, white and red) are located on the right side of the electrical board�
The green LED (CABLE PRESENCE LED) turns on each time the control cable is connected
and indicates that the transmission is taking place via cable and not via radio� When the
control cable is disconnected, the LED turns off and the machine switches automatically
to reception via radio�
The white LED (RX ON LED) turns on and flashes when the RX unit receives commands
via cable or via radio�
The red LED (ALARM LED) turns on in the case of a machine alarm�It may turn on flashing
or steady depending on the type of alarm�
NOTE
see the section
STOP COMMAND AND EMERGENCY PROCEDURE
in this manual to
identify the type of active alarm�
When the machine turns on the LEDs light up together for approx� two seconds for a
self-test�
The RX unit starts the hydraulic pump motor each time it receives a command from the
control lever's TX unit and the pump will remain in operation for an additional 5 seconds
after the last command is received�