TigoMaster 2TH
– EtherNet/IP
User Manual
Copyright © 2021 CoreTigo Ltd.
Page
25
of
75
Instructions:
1) Select a mounting location.
•
When mounting outside buildings
– Mount the device in such a way that it is protected from weathering,
especially from direct sunlight and the effects of UV light, salt water or salt spray, e.g., in a switch box
•
Only screw the device on flat contact surfaces to protect it from mechanical tension
•
Do not bridge any gaps with the unit to protect it from any tensile forces that may occur
•
To prevent damage to the unit, do not mount it in shearing areas of moving system parts. Also, lay the
cables in such a way that they cannot be caught in the shear zones of moving system parts
•
Leave sufficient space for easy replacement of the unit and for connecting the plug connections
•
Ensure requirements of the device for vibration and shock resistance are met at the installation site
•
Mount the device so that the diagnostic LEDs of the device remain visible
2) Initiate the installation procedure.
•
Disconnect the system from the power supply before you start installation
•
Ensure sufficient equipotential bonding in your system
•
During installation, make sure to not soil the connections. Dirt may damage the contacts
Warning:
Keep to the warnings below to prevent the device from heating during operation:
•
The cooling of the unit must not be impaired
•
Ensure an unobstructed air supply
•
Do not install the unit near strong heat sources
•
Do not mount the unit on or near highly inflammable materials
Users can attach the device directly to your system or in the control cabinet with screws. Fasten the device
to a flat, solid base with two M4 screws, each of which is screwed into a threaded hole.
See section 6 of this user manual for further details on the torque for tightening.
Note:
The device requires a connection to FE (Functional Earth) via the screws.
3) Connect the device to FE using screws.
•
Hold the unit in the desired position and mark the two points where the threads are to be cut. Verify
there is enough space around the device so that you can connect all cables without any problems
•
Cut an M4 thread at each of the two marked points with the M4 thread cutter
•
If necessary, pre-drill with the drill first
•
Screw the unit into the threaded holes with the Allen key using two M4 cylinder head screws of
suitable length at the upper and lower ends. Observe the tightening torque
4) Mount the
device’s SMA antennas.
•
All SMA antennas (X1, X2, and X3) must be mounted for proper device operation
