4
Push fit the 'short flipper seals' onto the top and bottom
edges of the fixed panels - flush against the metal profile.
Ensure the flipper seal 'flaps' are on the inside of the
fixed panels.
Note:
Wetting the glass with water will help to fit the seals.
5
Position the fixed panels into the wall channels and slide
down so they fully slot onto the end mouldings of the
bottom rail. Inside the enclosure, ensure the panels sit in
the 'fixed panel brackets', slide the brackets along the rail
and position under the panels as shown.
6
Position the top rail onto the top of the
'fixed panels'. Adjust the position of the
fixed panel brackets as required.
Line up the holes and fix using 2 x 13mm
screws.
4
Fixed
panel
bracket
Outside
face of
fixed
panel
13mm
Inside
Outside
face of fixed
panels
Outside
face of
fixed
panel
13mm
Inside
