12
Check the door frame is vertical and is centrally positioned between the corner post and wall channel.
From inside the enclosure, in the positions shown, drill through the corner post and wall channel into the fixed panel and
magnetic profiles using a 3mm drill bit,
do not drill too deep!
Fix using 6 x 10mm screws and screw caps.
ø 3
mm
From inside
10mm
8
Position the 'magnetic
profile' into the wall
channel and slide
down so that it fully
slots onto the end
moulding of the
bottom rail.
9
Position the top rail onto the top of the 'fixed panel' and
'magnetic profile'. Adjust the position of the fixed panel
bracket as required. line up the holes and fix using 2 x
13mm screws.
13mm
Inside
10
