10
Fit 'flipper seal' (PN40260) onto the edge of the fixed panel.
Ensure the flipper seal 'flap' is on the inside.
Note:
Wetting the glass with water will help to fit the seal.
From inside the enclosure, tighten all 2 fixed panel bracket
grub screws onto the glass using the allen key -
do not
overtighten
. Fit the cover caps (PN4745) into the holes.
11
Push fit 'flipper seal' (PN40259) onto the back edge of the door.
Ensure the flipper seal 'flap' is on the outside of the door.
Test the 'magnetic seal' (PN40258) against the 'magnetic
profile' to ensure it is the correct way around. Push fit
magnetic seal onto the closing edge of the door (the same
side as door handle hole).
Note:
Wetting the glass with water will help to fit the seals.
5
9
Check the door frame is vertical and is centrally positioned between the wall channels.
From inside the enclosure, in the positions shown, drill through the wall channels into the fixed panel and magnetic profiles using
a 3mm drill bit,
do not drill too deep!
Fix using 6 x 10mm screws and screw caps.
ø 3
mm
PN4745
Door
handle
hole
PN40259
PN40258
Outside
face of
door
From inside
10mm
Inside
PN40260
