11
6
Push fit the 'short flipper seals' onto the top and bottom
edges of the fixed panel - flush against the metal profile.
Ensure the flipper seal 'flaps' are on the inside of the
fixed panel.
Note:
Wetting the glass with water will help to fit the seals.
7
Position the fixed panel into the required corner post/
wall channel and slide down so it fully slots onto the end
moulding of the bottom rail. Inside the enclosure, ensure
the panel sits in the 'fixed panel bracket', slide the bracket
along the rail and position under the panel as shown.
Outside face
of fixed panel
Fixed
panel
bracket
Outside
face of
fixed
panel
a:
Place the bottom rail onto the tray with its end mouldings inserted into the corner post and wall channel.
b:
Centre the bottom rail between the corner post and wall channel so that there is an equal gap at each end.
5
a
=
=
b
