D2 W MDME 2400 Wireless Ethernet Modem
IF 1584 Rev. 1
IF 1584 Rev. 1
Page 24
My Right Boot 2.1
Copyright 1999-2004 Cybertec Pty Ltd, All rights reserved.
This software is provided by Cybertec ``as is'' and with NO WARRANTY.
http://www.cybertec.com.au/
ROM : 256KB @ 0xffe00000
RAM : 8192KB @ 0x00000000 (143KB / 0x00023d8c)
ROM Configuration table ... PASSED.
RAM address pattern check . PASSED.
RAM address bus check ..... PASSED.
Product : E24g
Variant : E2400P-300
Serial No. : 02060239 - 05061132900
Release : epm_mrb_elpro_E24g_1.65
Released date : 14 August 2006
Released host : Anxosity
Build date : Wed Sep 20 12:53:01 2006
Build host : Anxosity
Boot Flags : no RAM test, no ROM test, bus timer on, wdog on
static IP, auto-boot, net-boot, reset on
local file, no binary load
Boot delay : 0
Boot Filename : /memory/0xffe40000,0x80000
Boot Address : 192.168.0.112
Boot Netmask : 255.255.255.0
Boot Gateway : 192.168.0.1
Boot Host : 192.168.0.220
Boot Mac 0 : 00:12:af:00:03:05
Boot Mac 1 : 00:12:af:00:03:05
RTE data store .... no error
Setting bus timer (on) and watchdog (on) ... PASSED
802.11 Interface Power ON...
Reset 802.11 Interface...
Checking 802.11 NIC (Base Address: 0x30000000)
Register Read-Write Test...OK
Initialising..Successful
Getting Serial Number..Reading Buffer..
Serial Number: 99SA01000000
Done..
Recovery Configuration :
ip address : 192.168.0.112
net mask : 255.255.255.0
gateway : 192.168.0.1
host : 192.168.0.1
eip: mount point /memory
fec0: connected at 10M Half Duplex.
fec0: local ip = 192.168.0.112, server ip = 192.168.0.1
Press ENTER to abort automatic booting ... 5
e)
Check values for Boot Address, Boot Netmask, and Boot Gateway. These values should be set
to reflect those of the PC you are using to configure the unit. If these are correct, skip to Step
(h). You may check settings again with the
rct
command. For further help, type the
help
command.
f)
Set Boot Netmask to the same settings as the computer you have the Ethernet cable connected
to. This may be performed with the command:
bnm <Type the netmask>
g)
Set Boot Gateway to the same settings as the computer you have the Ethernet cable connected
to. This may be performed with the command:
bgw <Type the gateway IP address>
h)
Choose an IP address for the D2 W MDME 2400 being upgraded. This IP address must be on
the same network as the computer you have connected the Ethernet cable to. This may be
