Appendix B
Glossary
Page 75 November
2008
During the upgrade, the web page shows a progress bar at the bottom right side of the browser
window.
When upgrade is completed, the System Tools web page will be shown if “Save to Flash” was
clicked. If “Save to Flash and Reset” was clicked, the unit will display a message that the module
is resetting.
Firmware upgrade is now complete.
Manual Upgrade using Flash Update
1.
Connect the module’s Ethernet port to PC Ethernet port via a straight-through Ethernet
cable. Straight-through Ethernet cable is typically a blue color.
Alternatively, connect the module to PC via a network switch or hub,
as some
configurations of Windows can encounter difficulty upgrading without a hub connected.
On some PCs, Windows can take much longer than expected to initialize its network
interface when the device is reset - connecting via a hub/switch removes this issue during
the upgrade procedure.
2.
Switch dip switch on module to
SETUP
mode.
3.
Power up
the module and wait a couple seconds. This will ensure that Windows
networking can correctly detect an operating Ethernet port.
